SnapShot Camera Installation Guide
Page 6 of 12
4. Connections
The camera requires a low voltage 24V AC supply (1A). Connect the
incoming power cable to the push terminals marked LV INPUT 24v ac.
Important!
Do not connect mains power (240v) to this camera or there will be a
serious risk of injury and the equipment will be damaged.
The camera housings are
factory sealed and should not
be opened.
The
ANPR
and
optional
overview cameras are each
pre-wired and supplied with
protective
flexible
steel
conduit, terminated with a
moulded RJ45 connector. The
ANPR camera has a blue
cable
and
the
optional
overview camera has a red
cable.
Connect
to
the
corresponding JB socket as
shown (left).
Important!
Do not connect these RJ45 plugs or sockets to any other networked
equipment or wall socket, otherwise damage will occur.
The analogue video output(s) are provided by way of two BNC sockets
within the junction box.
Finally, if you intend to control the camera zoom and focus from a remote
SNAP processor, connect your RS485 telemetry cable to the push
terminals marked A+ and B-.