SnapShot Camera Installation Guide
Page 5 of 12
3. Fixing the Camera
The camera can be mounted to a wall
using the standard bracket. This
bracket provides adjustment of the
camera pan and tilt by way of separate
adjustment bolts.
Wall Bracket
If you need to mount the camera from the top of
column, a pole mount bracket is also available.
This uses standard 4” PCD (101.4mm) fixing
centres and will mate with a wide range of third
party poles and brackets.
Pole Mount Bracket
The camera is supplied with an IP66 junction box which should be
mounted adjacent to the camera. A flexible steel conduit (two where an
optional colour overview camera has been added) connects the junction
box to the camera and is normally 1m in length.
The junction box should only be
fixed using the holes provided.
These are outside the sealed area
to ensure the enclosure remains
water tight.
Important!
You must not drill additional
holes in the enclosure as this
will invalidate the warranty.
A steel backing plate is provided to simplify fixing. Do not remove the
circuit board from the enclosure.