12
INSTALLATION MANUAL
3.
XTO-IP
PANEL PROGRAMMING
XTO-IP
Alarm panel
IP
PARAMETERS ?
OK
or
YES
ETHERNET parameters configuration
DHCP :
ENABLED
PANEL IP
DHCP :
DISABLED
OK
or
YES
IP MASK
GATEWAY
PRIMARY
DNS
SECONDARY
DNS
IP
PARAMETERS ?
ESC
NO
ETH. STATUS?
TEST IN PROGRESS
END = OK/YES
ESC
NO
OK
or
YES
PANEL IP
XXX.XXX.XXX.XXX
ETH. STATUS?
ESC
NO
ESC
NO
During this test, the panel tries to connect to the
local Ethernet Network. The result of this test
can be:
•
If the connection is successful:
the local IP
of the panel will be displayed
(you can
display other Ethernet parameters with the
arrows
).
•
ETHERNET OFF NO STATUS
: the
Ethernet module is switched off. Please
verify that the Ethernet cable is connected
and try again.
•
NETWORK/CABLE MISSING
: the panel
doesn’t detect Ethernet Cable or Network.
By setting the DHCP as ENABLED,
a new IP address will be assigned
dynamically to the panel every
time it connects to the network.
Network parameters will not be
asked.
If the router forces a static IP
address for the panel, there will
then be a need to define DHCP
as DISABLED. You will then need
to fill in the following network
parameters fields :
Panel IP, IP
Mask, Primary DNS, Gateway
and Secondary DNS.
Warning: Verify that the IP
address selected is available on
the Network and accepted by the
router.
OK
or
YES
