00
7
Videofied Security System Installation Manual
4. End of installation
You have recorded and fix all the devices, record the remote controls, then with the question :
Display of the keypad
Actions and commentaries
ENTERING A NEW
DEVICE ?
OPERATION
COMPLETED ?
SYSTEM CHECK
IN PROGRESS
INSTALATION
SUCCESSFUL !
(Close the cover of the panel)
All that remains is to program the user
codes, Partial arming modes and eventually
the Intercom time (at 180 seconds).
5. How to...
5.1 Program partial mode
With the direction arrows
go to the menu
CONFIGURATION
(niv
4)
->
ALARM
MODES
PROGRAMMABLES
->
FULLY ARMED
Then use the direction arrows to select the relevant arming
mode and the [YES] key to modify it.
There are three possible arming modes.
NORMAL MODE is the general arming mode, set using a badge
or with a user code and keys
or
.
MODE SPECIAL1 is a partial mode activated by entering a user
code and pressing the . This mode is also accessible on a
CMA keypad via the and via an RC remote control via
the .
SPECIAL2 MODE is not accessible on the keypad of an XL
panel. It is available on a CMA keypad via the and via an
RC remote control via the .
For each arming mode, it is possible to specify how each of the
4 zones will be armed and how the sound alert will be made.
Areas : 1 2 3 4 Each time you press on the number
of the area it modifies the correspondance.
State : A A A A Situated below. Validation at the end, the
[YES] key.
A
Armed
Siren
Immediate triggering
of all sirens
D
Disarmed
Delay
beeps
Entry/Exit delay
beeps, then triggering
of the sirens
P
Perimeter
(all the opening
contacts)
Silent
Without siren
without beeps
E
External
(opening
contacts protecting an
exterior access)
Without
siren
Beeps on the
keypad only
PERIMETRIE MODE is not accessible on the XL keypad. It is
only availble on the CMA deported keypad by
+ user
code + [YES].
You can now close the XL panel, making sure you fully tighten the screw on the left-hand side.
