4455 White Bear Parkway, Suite 700
White Bear Lake, MN
55110
USA
T o l l F r e e : 8 7 7- 2 0 6 - 5 8 0 0
F a x : 6 51-76 2 - 4 6 9 3
www.videofied.com
© 2007 RSIalarm™ Videofi ed
®
is a Registered Trademark of RSIalarm™.
S
2
View is a registered trademark of RSIalarm™. Specifi cations subject to change without notice.
Mounting
>
Use proper tools and hardware.
>
Mount indoors in a temperature-controlled environment.
>
Mount camera 7.5 to 9 ft. (2.3 to 2.8 m) from the fl oor.
>
Mount detector on an outside wall, aimed at area to
be
secured.
>
Do not aim detector at windows, especially those that
let in direct sunlight, or at heat sources such as lamps,
fi replaces, radiators, and heating vents.
>
Do not aim detector at moving objects such as curtains,
fans, or animals weighing more than 40 lbs. (18 kg).
Regulatory Information
FCC Part 15
This device complies with FCC Rules Part 15.
Operation is subject to the following two conditions:
1.) This device may not cause harmful interference
and, 2.) this device must accept any interference that
may be received, including interference that may cause
undesired operation.
Changes or modifi cations not expressly approved by
RSIalarm, Inc. can void the user’s authority to operate
the equipment.
Specifications
Panel Compatibility
V-6000
Operating Frequency
915 MHz. 25 frequencies
Radio type
Spread Spectrum Bidirectional RF
Power Requirements
Three 3.6 V lithium batteries
Battery Type
LS14500
Motion detection
Lens: Fresnel
Detection distance: 40 ft./12 m
Angle:
90°
Detector type: Dual elements
Weight threshold: 40 lbs./18 kg
Camera sensor
CMOS black & white
Video resolution
320 x 240 pixels
Video sequence (in alarm)
5 frames/s for 10 seconds
Video sensitivity
.2 lux
Lens
Wide-angle 85° (no IR treatment)
Night illumination type
Infrared (LEDs)
Night illumination distance
14 ft./ 4.5 m
Operating Temperature
32° - 104° F (0° - +40° C)
Maximum Relative Humidity
70%, non-condensing
Dimensions (LxWxD)
3-1/2 in. x 2-3/4 in. x 2-3/4 in.
(89 mm x 70 mm x 70 mm)
Weight
5.3 oz./150 g (without batteries)
UL Listings
1023 (applied for)
1
Separate base from camera.
2
Hold camera base against
mounting surface and mark the
two appropriate mounting holes.
3
Drill pilot holes and install anchors
where
needed.
4
Place base on mounting surface
so holes line up with pilot holes
/anchors and secure base with
appropriate
screws.
5
Install batteries into camera, observing correct polarity.
6
Attach camera to base and secure with screw.
Flat Wall Mounting
Corner Mounting Holes
I N S T A L L A T I O N I N S T R U C T I O N S
Camera Model DCVA 600
