5.8GHz DeskTop Video Series Manual Rev. C 2007
2
TABLE OF CONTENTS
TABLE OF CONTENTS .............................................................................................. 2
SAFETY NOTICES ...................................................................................................... 2
INTRODUCTION......................................................................................................... 3
PARTS LIST ................................................................................................................. 4
SYSTEM SETUP .......................................................................................................... 5
Channel Selection........................................................................................................ 5
Conducting a Bench Test............................................................................................. 6
TIPS & TROUBLE SHOOTING ................................................................................. 7
SPECIFICATIONS....................................................................................................... 9
WARRANTY INFORMATION/ TERMS & CONDITIONS ................................... 10
SAFETY NOTICES
I.
THIS DEVICE COMPLIES WITH FCC RULES PART 15.249 OPERATION IS SUBJECT TO THE
FOLLOWING TWO CONDITONS:
(1)
This device may not cause harmful interference, and
(2)
this device must accept any interference, including interference that
may cause undesired operation of the device
II.
In order to comply with the FCC/IC adopted RF exposure requirements, this transmission system will be
installed by an authorized professional installer of VideoComm Technologies. Installation of all antennas
must be performed in a manner that will provide at least 23cm clearance from the front radiating aperture, to
any user or member of the public.
III.
This is NOT an intrinsically safe device. Do not take into area where intrinsic safety is required. Bodily
harm may result if warning is ignored.
IV.
DO NOT OPERATE TRANSMITTER WITHOUT ANTENNA CONNECTED TO ANTENNA PORT.
Failure to do so will result in damage to the unit and void the warranty.
V.
DO NOT OPERATE THE SYSTEM WHEN the Transmitter & Receiver are closer than ten feet to each
other. The devices may not work properly and permanent damage can occur.
VI.
The device has been certified by the FCC for use with other products without any further certification (as per
FCC section 2.1091.) Changes or modifications not expressly approved by VideoComm Technologies could
void the user’s authority to operate the equipment.
The term “IC:” before the radio certification number only signifies that Industry Canada
Technical specifications were met.
