video xtreme VX-22d, Owner'S Operating Manual

Page: 70 / 84

Operation
58 Runco VX-22d Owner’s Operating Manual
PRE
L
IMINAR
Y
Trigger s : Select Triggers from the Service menu to configure the 12-volt trigger outputs.
You can assign one or more trigger outputs to each aspect ratio. Those triggers are then
activated by selecting that aspect ratio.
If your projector is equipped with the Runco CineWide with AutoScope system, assign at
least one trigger output (the same one to which the lens motor is connected) to the
Cinema and Virtual Cinema aspect ratios.
Mi s cellaneou s : Select Miscellaneous from the Service menu to set the following options:
• Language: Select Language from the Miscellaneous menu and press the up- or
down-arrows to select the OSD Language (English, Français, Deutsch, Español or
Italiano).
• O S D Timer: Select OSD Timer from the Miscellaneous menu to set the OSD Timer,
which controls how long the menus remain on-screen after selecting them. Select from
5 to 60 seconds, in one-second increments. Or, set the timer to 0 (disabled) if you want
the menus to remain on-screen indefinitely.
• Film Mode: Use Film Mode to smooth out moving images from interlaced,
standard-definition (SD) sources. In most cases, the VX-22d detects the proper
“pull-down” rate and vertical frequency. However, if your source is jittery and/or tearing
you may wish to enable Film Mode (ON) to ensure stable processing for that source.
S y s tem Re s et: To reset ALL projector and controller settings (including image settings)
back to their factory defaults, choose System Reset from the Service menu.
A confirmation message appears, reminding you to save your settings before you perform
the reset, so that you can restore them afterwards. If you have done this, select Confirm to
continue with the reset. Otherwise, click Back to cancel.
Re s tore S aved S etting s : Following a System Reset, select Restore Saved Settings,
then select Yes to apply all previously-saved settings to the projector and DHD Controller.
This action is not undoable. Proceed with caution! Before you
perform a System Reset, save your “Custom” ISF presets (page 54)
and ISF Day/Night presets (page 56).
Caution