Vidao VSB2500, Manual

Page: 5 / 12

REMOTE CONTROL BATTERY INSTALLATION
The remote control operates on one CR2025 battery (included). To activate the remote control, remove
the insulation tab inserted in the battery compartment. To remove the tab, pull it in the direction of the
arrow in the illustration as shown.
When the operation of the remote control becomes intermittent or unsatisfactory, replace the original
battery with a new 3-volt lithium battery.
Replacing the battery in the remote control:
1.) Press on the side of the battery holder and pull the holder out of the remote.
2.) Remove the old battery and then install 1 new “CR2025” lithium battery according to the polarity diagram on the
battery compartment.
3.) Insert the battery holder into the remote control and make sure it locks into place.
NOTE: Only use a well-known brand of battery to ensure the longest life and best performance.
Battery Precautions
l Replacement of batteries must be done by an adult.
l The supply terminals are not to be short-circuited.
l Non-rechargeable batteries are not to be recharged.
l Exhausted batteries are to be removed.
l Only batteries of the equivalent type are to be used.
l Batteries are to be inserted with the correct polarity.
l Dispose of batteries properly. Do not dispose of batteries in fire.
The batteries may explode or leak.
WARNING
DO NOT INGEST BATTERY,
CHEMICAL BURN HAZARD
The remote control supplied with this product contains a
coin/button cell battery. If the coin/button cell battery is
swallowed, it can cause severe internal burns in just 2 hours
and can lead to death.
Keep new and used batteries away from children. If the battery
compartment does not close securely, stop using the product
and keep it away from children.
If you think batteries might have been swallowed or placed
inside any part of the body, seek immediate medical attention.