Vidalux Hydro Plus Series, Installation And Operating Manual, Page: 11 / 35

DO NOT SCREW THE PANELS TO THE BASE JUST YET
9
TIP: Only fi t each
screw loosely at
first to allow
enough
movement to
locate every
screw hole. Once
all screws are
located in place,
then tighten
each up fully.
DO NOT PLACE
SEALANT IN THE
WATER CHANNELS
REAR PANEL ASSEMBLY
First, attach one panel to the center column with a fixing in the
top and bottom of the column to the rear panel. This will offer
some stability. Do not fully tighten yet
Now continue to fix the remaining back panel. At this point you
can add all the remaining fixings to both sides, making sure
everything is aligned and level and fully tighten each
NOTE: A bead of sealant MUST be run between the joining
faces of the back panels
to the
Center Tower to provide
an extra level of water protection.
Do not worry about making a slight mess.
You will remove any excess sealant once the panels have
been fixed into position.
DO PUT SEALANT IN TO THE
WATER CHANNELS
You should consider doing this on all panels with meeting
faces then simply wipe off any excess so none will be 'on
show'
. This includes under the back panels and center
control tower where it sits on the tray
Locate the two rear, framed glass panels.
The inside edge to go to the center control panel will be flat. The
outside end to connect to the frame work will have a 'T' end and 90
degree return