Victron energy MultiPlus 12/3000/120-16, Manual

Page: 26 / 44

5.3 Configuration by computer
All settings can be changed by means of a computer or with a VE.Net panel (except for the
multi-functional relay and the VirtualSwitch when using VE.Net).
Some settings can be changed with DIP switches (see Section 5.2).
For changing settings with the computer, the following is required:
•
VEConfigure3 software: can be downloaded free of charge at
www.victronenergy.com.
•
A MK3-USB (VE.Bus to USB) interface.
Alternatively, the Interface MK2.2b (VE.Bus to RS232) can be used (RJ45 UTP
cable needed).
5.3.1 VE.Bus Quick Configure Setup
VE.Bus Quick Configure Setup is a software program with which systems with a maximum
of three MultiPlus units (parallel or three phase operation) can be configured in a simple
manner.
The software can be downloaded free of charge at www.victronenergy.com.
5.3.2 VE.Bus System Configurator
For configuring advanced applications and/or systems with four or more MultiPlus units,
VE.Bus System Configurator software must be used. The software can be downloaded
free of charge at www.victronenergy.com .
5.4 Configuration with a VE.Net panel
To this end, a VE.Net panel and the VE.Net to VE.Bus converter are required.
With VE.Net all parameters are accessible, with the exception of the programmable relay and
some other advanced settings.