12
REQUIRED HARDWARE IN THIS STEP
NO
.
DESCRIPTION
SKETCH
QTY
1 Nut
4 pcs
2 Spring
Washer
4 pcs
3 Flat
Washer
4 pcs
6 Open-End
Wrench
1 pc
A S S E M B LY I N S T R U C T I O N S - C H A I R
1.
Remove the plastic plugs protecting the bolts from the
front legs (F). Attach two front legs (F) to seat frame (G)
using nuts (1), spring washers (2) and flat washers (3).
Don’t tighten the nuts at this time.
Note: The chair seat frame (G) has one screw hole in each
side and one in the front to attach the chair seat at a later
step. These holes are wider on the bottom and narrower
on the top. Ensure the wider holes look down towards
the bottom of the chair legs (F).
a
b
G
F
F
F
Ensure wider end of
holes face towards
the bottom of the
chair legs
PLASTIC PLUG
G
1
2
3
1
2
3
6
