05.2016
INSTRUCTION MANUAL
for installation and operation
9
For the good functioning of the cooker, it is necessary to achieve enough draught of the
chimney. This depends on both its height and the environment temperature. If the environment
temperature exceeding 14
C disturbances in the combustion caused by insufficient draught
might occur. In this case it is necessary to load the cooker with less fuel and the regulators to be
left open so that the fuel to be burned faster (with flame) and thus reaching a stable flue draught
in the chimney. In this case it is necessary to clean the ashpan more often.
5. Important instructions for fire-precaution and safety regulations.
The door of the firebox should always be firmly closed even when the cooker is not
working.
The cooker should be installed only on a non-combustible floor.
The cooker and the chimney pipes should be at least 80 cm away from combustible
objects or constructions.
The top plate of the cooker (frame and plate) should be at least 100 cm away from
combustible objects or constructions.
Using easily inflammable liquids at ignition is not allowed.
Vertical connection of chimney pipes with the chimney through floor structures is not
allowed.
The presence of easily inflammable and explosive substances in the heated room is not
allowed.
The ash disposal and the cleaning of the cooker should be done only at safe places and
when the cooker has cooled down.
The cooker is intended to local heating of chambers with normal fire hazard.
It is prohibited to put combustible materials and objects on the cooker or in the
immediate proximity of it.
The cooker is not intended to be built in kitchen furniture.
Please pay attention during the operation of the cooker children to be kept away from it, because
its surface is too hot.
Incineration danger!
We recommend the following instructions in case of a chimney fire:
Close the combustion air regulator!
Call the fire brigade in your neighborhood!
Do not try to extinguish the fire with water by yourself!
All easily inflammable materials to be away from the chimney!
When the cooker is set to work again it is necessary the chimney to be checked by a
competent person for eventual damages
When the cooker has been overworked over the limited heat output or for a
longer period, and also when using fuels other than the recommended by the
manufacturer, then we cannot guarantee reliable work of the cooker.
Please do regularly with the help of a specialist a full check of the cooker related to its
functionality. Replace the defected parts only with the spare parts manufactured and supplied by
Do not make any non-authorized changes into construction of the cooker!
6. Cleaning.
The correct maintenance and cleaning of the cooker guarantee its reliable work and keeping its
good appearance.