Victor VC02, Operation Instruction Manual

Page: 5 / 18

5
the the the
the
following following following
following
steps: steps: steps:
steps:
1) Remove the test leads and turn off the power supply of the calibrator.
2) Remove the holster from the calibrator. Open the battery cover
at the back of the calibrator by unlocking it in the indicated
direction.
3) Replace the used-up battery with a new one. Put the battery
cover back and lock it in the indicated direction.
4) Put the holster back onto the calibrator.
4.
4.
4.
4.
Power-On/Off
Power-On/Off
Power-On/Off
Power-On/Off
of
of
of
of
Calibrator
Calibrator
Calibrator
Calibrator
4.1
4.1
4.1
4.1
Power-key
Power-key
Power-key
Power-key
operation
operation
operation
operation
Press the power key to turn on the power supply of the calibrator.
Then press it again to hold it in one second and the power
supply will be off. When the power supply is turned on, the
calibrator will start to make self-diagnosis internally and the full
screen is in display. After this, appropriate operation should be
carried out.
N N N
N
ote ote ote
ote

P
P
P
P
ower-on
ower-on
ower-on
ower-on
: To ensure the correct operation of the calibrator with
power on, it is good practice to turn off the power
supply pausing 5 seconds, and then restart the
calibration.
4.2
4.2
4.2
4.2
Automatic
Automatic
Automatic
Automatic
power-off
power-off
power-off
power-off
By the shipping time, the calibrator is set for automatic power-off
function in the factory like this: In case there is no operation of
the calibrator within 10 minutes after power-on, it will cut off the
power supply automatically. However, users can decide whether
they want to use the function of the automatic power-off or not. The
setting can be done by themselves. (See section 7)
5
5
5
5
.
Output
Output
Output
Output
from
from
from
from
calibrator
calibrator
calibrator
calibrator
The output terminal of the calibrator produces a DC voltage set by
the user or produces an analog temperature signal from a thermo-