I-V9
INSTALLATION INSTRUCTIONS
Style V9 Victaulic
®
FireLock
™
IGS
™
Installation-Ready
™
Sprinkler Coupling
For complete contact information, visit victaulic.com
I-V9 11351 REV B UPDATED 11/2018 Z0000V9000
VICTAULIC, FIRELOCK, IGS, AND INSTALLATION-READY ARE REGISTERED TRADEMARKS OR TRADEMARKS OF VICTAULIC COMPANY AND/OR
ITS AFFILIATED ENTITIES IN THE UNITED STATES AND/OR OTHER COUNTRIES. © 2018 VICTAULIC COMPANY. ALL RIGHTS RESERVED.
Larger Opening
of Housings to
Larger Opening
of Gasket
6. REASSEMBLE STYLE V9:
Place the lubricated gasket inside
the gasket pocket of one Style V9 housing.
NOTE:
For all sizes other
than the 1-inch x 1-inch/33.7-mm x 33.7-mm, verify that the larger
opening of the gasket is facing the larger opening of the housings, as
shown above. Engage the tab of the one housing with the slot of the
other housing, and close the housings around the gasket.
Head of Bolt Shall
Face Angled Feature
of Bolt Pad
7. INSTALL BOLT:
Install the bolt through the housings. Verify that the
head of the bolt faces the angled feature of the bolt pad, as shown
above.
8. INSTALL NUT:
Thread the bolt into the nut until the top of the nut
is flush with the end of the bolt, as shown above. Verify that the gasket
remains seated in the gasket pocket of the housings and that the nut is
engaged with the flat features of the bolt pad.
WARNING
• The sprinkler shall be replaced upon disassembly of a Style V9.
Verify that the replacement sprinkler is the proper model, style,
orifice size, temperature rating, and response.
Failure to follow this instruction could cause improper sprinkler
operation, resulting in death or serious personal injury and property
damage.
9. INSTALL NEW SPRINKLER:
Insert a new sprinkler that is the proper
model, style, orifice size, temperature rating, and response into the
corresponding opening of the Style V9 housings. Rotate the sprinkler so
that the frame arms align with the bolt pads, as shown above.
10.
Follow steps 4 – 7 on pages 2 – 3 of this instruction sheet to
complete the assembly.
