Quick Guide
|
7
Rev 512
•
Position the monitor(s) in a permanent fixed location.
Connect the
monitor to the appropriate connector, DVI or HDMI (a DVI-VGA adapter
can be used if required).
Note
There is a ferrite supplied in the accessory kit. To comply with FCC and
CE, this ferrite must be installed onto the VN-DECODER-2V8 side of the
HDMI cable.
•
Insert one side of a standard LAN cable to the network port’s RJ-45
connector. Insert the other RJ-45 connector into the LAN side of the
network.
•
Insert the connector of the provided power supply into the
VN-DECODER-
2V8
’s
power receptacle
.
Do not connect the
remaining end to a power receptacle until instructed.
•
Connect the monitor(s) to the power source and switch on.
To ensure that the VN-DECODER-2V8 is protected during a power failure
and that no important data is lost, it must be connected to an
uninterruptible power source (UPS) before use.
•
Connect the VN-DECODER-
2V8
's power supply to the UPS power
receptacle.
•
Connect the UPS power cord to the wall outlet.
•
Power on the UPS and ensure that it is working properly.
•
Power on the VN-DECODER-
2V8
.
