14
Configuring the Network Settings
Note:
Before starting, make sure that VNSetup.exe is installed on the configuring PC\workstation. the
VNSetup is found on the included CD, VN-755IP Software.
There are two ways to change the IP camera network settings:
•
Activating the camera for the first time: via VNSetup.exe application.
•
Camera connects to an active Nucleus: via ViconNet application (connection to Nucleus is necessary).
Using the VNSetup
1.
Make sure the MAC address of the camera is available. Use MAC Address log provided.
2.
Verify that the camera is physically connected to the network.
3.
Run the VNSetup application (double click on VNSetup.exe)
4.
Using the camera's MAC address, select it from the TX Selection list (See Figure below).
5.
Enter the Nucleus IP address.
6.
Enter the following network parameters: IP Address, Net Mask and Gateway (See Figure below).
7.
If the network operation is fixed IP address method, do the following:
•
Open the network settings window (refer to the "Using the ViconNet application" section).
•
Select the "Specify an IP address" option.
•
Enter the network parameters (see your IT administrator).
•
Click OK. Application in the camera should restart.
Transmitter (TX) Selection List Screen
XX156-00-01 Rev 705 VN-755IP Camera
Summary of Contents for VN-755IP
Page 2: ......
Page 4: ......
Page 16: ...12 XX156 00 01 Rev 705 VN 755IP Camera...
