■
CAMERA SETTINGS
①
DIP Switch Functions
(1) Compensating for backlight
(2) Confirming the iris setting
ON
When back light is too bright
AE (OFF)
When fixed iris lens is installed
OFF
Normal setting
ME (ON)
When DC autoiris lens is installed
CAUTION
: It will be correctly set by adjusting DC lens control.
CAUTION
: The iris setting is preadjusted as the best condition for
use at time of factory shipment, so it isn't necessary to change settings
(3) Confirming the white balance
(4) Setting gain control (AGC)
For adjusting the sensitivity of the camera. Use this setting for shooting
in dark environments.
ON
Normal setting
OFF
Set this when there is excessive noise
②
Second Video OUT Connector (Option)
⑤
Adjusting Level Volume
If installer is setting with portable monitor, this connector is
If the entire image is too dark or bright, or the backlight
used.
compensation is not correct even after
①
is set to "ON",
you need to adjust the level volume.
③
IR LED Connector (Option)
CCW (Low)
Closes the lens iris, making the entire image darker
If extra IR LED board is attached, this connector is used.
CW (High)
Opens the lens iris, making the entire image brighter
④
Setting Monitor Synchronization
⑥
DC Varifocal Connector
(24VAC adaptor users)
This should be used with
⑤
DC IRIS LENS.
Vertical sync disturbance may occur when a selector is used to
switch between multiple cameras connected to one monitor.
To prevent vertical sync disturbance, adjust
④
.
⑦
Power Connector
CAUTION
Connect with AC/DC power, board attached inside.
* When using the 12VDC adaptor, sync setting is set to internal sync.
ATW (ON)
Use this under light source below 2500K and over
9500K of natrium.
AWB (OFF)
Use this under light source between 2500K and 9500K of
fluorescent lamps, incandescent light
CAMERA SETTINGS
①
①
Portable
Monitor
②
③
④
⑤
⑥
DC VARIFOCAL
⑦
