7
Installing & Adjusting Camera
Select a location that is clear of obstacles and can support the weight of the unit. Exercise maximum caution
when installing the unit to the wall or ceiling the unit falling can result in injuries and accidents. It is recommended
to install the camera 2-4 meters from the floor. As a failsafe against falling, attach the unit by chain, wire cable
or other safety restraint to an appropriate anchor point.
The infrared laser will turn on in the low light conditions and 5 tiny red dots will be visible. Do not look directly
at the lens of the camera as it may impair eyesight.
Step 1: Prepare the mounting holes
To provide for cable management, the camera can be mounted to a back box, model V940B-BOX.
Note: Make sure there is room for a cable routing hole at the location and drill a hole to route the cables.
Cabling should be routed to the installation location.
The V940B-BOX consists of two pieces (bottom and cover) and is supplied with a mounting template and
hardware necessary to mount it. Using the mounting template, prepare the three mounting holes. Secure the
bottom of the box to the surface using the screws and anchors supplied or hardware appropriate for the
mounting surface. There are three cable access holes provided, one on the side and two on the rear. Route the
cables through one of these access holes.
Step 2: Install the camera
Route the cables from the camera through the cable access hole in the cover. Insert the slit in the white foam
plug onto the cable assembly from the camera and insert the plug into the cable access hole in the cover.
Route the camera cable assembly through the metal cable plate provided and secure this entire assembly onto
the back box cover with screws provided.
Secure the camera to the back box cover in the circle inset using the screws and washers provided in the
accessory kit. Align the standoffs in the bottom with the holes in the cover and secure the cover/camera
assembly to the bottom of the back box.
Cable access holes (3X)
Standoffs for camera
mounting (4X)
Mounting holes (3X)
Cable access hole
Insert cables from camera.
Secure with foam plug and
metal plate provided.
