PLASTIC CAP
T
AMPER RESISTANT
RELEASE
\
\
SCREW WITH SEALING WASHER
WEEP HOLE (3)
6.00 in.
(15.24 cm)
SIDE VIEW
FRONT VIEW
Figure 1
Housing
2.1 Installation of the Housing
The housing may be mounted directly to a solid ceiling.
CAUTION:
This unit should not be mounted to a
If it is to be mounted to a pole or vertical wall surface
A
dry-wall surface or an acoustic tile or other
using the
Mounting Adapter, refer to
dropped-ceiling surface. It must be mounted on
tion Manual X8 19.
a surface which is strong enough to bear its
FASTENER NOTE:
In the following instructions,
where the manual indicates
(UNC-standard)
bolts, screws, and nuts, metric
x
1.0 hardware
may be used. Where the manual indicates
lag bolts or other
fasteners that must be
supplied by the installer,
equivalent fasteners
may be used. Wherever equipment must be mounted
to built-in threaded studs in the housing or wherever
the housing or its accessories have prethreaded
holes, the studs and holes will be threaded and tapped
for UNC or UNF standard fasteners, and the mating
fastener will be supplied in the accessory pack with
the product.
weight and resist unauthorized attempts to dis-
lodge it.
If the housing is being mounted on the ceiling near a
wall, leave an appropriate amount of clear area imme-
diately behind the hinge end of the unit so that the
housing may be opened fully without striking the wall.
The base of the housing has two cable access holes and
four screw holes for ceiling mounting. A dimensional
drawing is provided (Figure 2) to assist in locating the
mounting and cable holes
x795-197
3
