16
•
Maintenance
X777-08 Rev 1202 Intelligent Remote Control Panels
RS-422 J1 Connector (pin 1 is the leftmost pin as viewed from the rear of the unit):
2
8
3
9
RS-232/RS-485 J29 Connector (pin 1 is the top right pin as viewed from the rear of the unit):
2
3
4
5
2. Press and hold the F1 key and then press the SEQ key to enter the programming mode.
3. Press SEQ repeatedly until “Enter Diagnostic Mode” displays. Press PP ENTER to perform the first test
or SEQ to select the next test (BYPASS selects the previous test). Tests are performed in the order listed
in the previous table.
4. Press RUBOUT three times to exit the diagnostics mode or to stop a test that is being executed.
Note: You may also enter diagnostics mode by removing power from the keypad and then setting DIP switch
SW39 pole 3 to OFF on the rear panel. Reapply power to access diagnostics. After completing
diagnostic tests, remove power and reset SW39 pole 3 to ON. Do not change the other pole settings.
Maintenance
Defining the Joystick Control Range
Use this procedure to define:
•
how much deflection from the center position is required before a function is activated, and
•
how far the joystick needs to be deflected from the center position in order to reach full speed.
1. Press and hold the F1 key and then press the SEQ key to enter the programming mode.
2. Press SEQ repeatedly until “Enter Diagnostic Mode” displays in the STATUS window.
3. Press PP ENTER.
4. Press SEQ repeatedly until “A/D” appears in the STATUS window.
5. Press PP ENTER.
6. Define the point at which the pan or tilt begins to operate by deflecting the joystick to the desired position.
Hold the joystick at that point and press AUX2. Use this step if pan and tilt activity continues even though
the joystick has been released and returns to center. Make sure that “- -“ displays in the center window in
order to verify that the joystick returned to center.
7. Deflect and hold the joystick to the right, to the position at which full pan speed should be reached.
8. Press and release the AUX1 button to lock in this position.
9. Deflect and hold the joystick to the left, to the position at which full pan speed should be reached.
10. Press and release the AUX1 button to lock in this position.
11. Deflect and hold the joystick up, to the position at which full tilt speed should be reached.
12. Press and release the AUX1 button to lock in this position.
13. Deflect and hold the joystick down, to the position at which full tilt speed should be reached.
14. Press and release the AUX1 button to lock in this position.
Note: This test must be run with SW39
pole 1 in the OFF position.
Summary of Contents for Nova V1300-DVC
Page 2: ......
