Preparing for use
42
Adjusting the
working depth
Begin adjustment work with the front rotor:
Use the tractor's hydraulic control device to move the machine into
the headland position.
Close the ball valve.
Switch off the tractor and secure it.
Release the adjusting nut below the chassis using the catch and
use the adjusting nut to adjust the working depth.
Use the catch to prevent the adjusting nut from moving.
Switch on the tractor.
Lower the machine.
Switch off the tractor and secure it.
Check the working depth and readjust it if required.
Two turns of the adjusting nut change the height by 15 mm on the
tines.
Spanner size “65” on the adjusting nut.
Set the working depth on the rear rotor.
Match and adjust the contact roller axles [+] to the height of the
chassis axles (basic setting H = 35 mm).
Adjusting
Catch
Chassis cylinder
Summary of Contents for Andex 714 T Evo
Page 4: ...4 ...
