5
Operating Instructions V750 Series
Liquid Inhalants such as Vicks VapoSteam
®
or Kaz Inhalant can be used in the medicine cup.
ONLY USE LIQUIDS THAT ARE RECOMMENDED FOR THIS TYPE OF HUMIDIFIER.
1.
Add 1 TB (Table Spoon) inhalant to the medicine cup.
2.
Note: Some residue from inhalant may be left in medicine cup after use. With the humidifier
turned off, unplugged and cooled for at least 20 minutes, gently wipe residue from medicine cup.
3. DO NOT
ADD LIQUID INHALANTS OR ANY ADDITIVES OTHER THAN THOSE
RECOMMENDED BY THE HUMIDIFIER MANUFACTURER TO THE WATER. DOING SO CAN HAVE
ADVERSE EFFECTS ON THE HUMIDIFIER.
Using Liquid Inhalant
Step 1
Step 2
Step 3
Step 2
Step 1
Liquid Inhalant
Step 3
1. Power:
With the power switch in the OFF position ( ), plug the filled humidifier into a
polarized 120V outlet.
DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET
; It will
only fit one way.
DO NOT
plug in humidifier with wet hands to avoid electric shock.
2. Output:
Set output control to high (
) or low ( ).
Indications your humidifier is operating are that the green nightlight on the control knob will
illuminate and after 1-2 minutes your humidifier will produce a visible steam.
3. Humidity Level:
Once you have reached a comfortable humidity level your humidifier
should be turned to the low setting. A comfortable humidity level is between 40-60%.
To monitor your humidity level it is recommended you use a hygrometer such as the Vicks
V70 or V70-CAN model. If you notice condensation on the walls or windows you should turn
your humidifier off as your humidity level is too high.
4. CAUTION: DO NOT
remove the Mist Chimney, Removable Tray, Water Tank or
Medicine Cup when humidifier is in use or for at least 20-30 minutes after unit has been
turned off and unplugged.
CAUTION:
WHEN MOVING HUMIDIFIER. TURN HUMIDIFIER OFF, UNPLUG and WAIT
20-30 minutes.
DO NOT OPERATE YOUR HUMIDIFIER WITHOUT THE TANK IN PLACE
OR IF THE UNIT IS EMPTY. DO NOT OPERATE YOUR HUMIDIFIER WITHOUT THE MIST
CHIMNEY, REMOVABLE TRAY, OR MEDICINE CUP PROPERLY ASSEMBLED.
Step 4
