Viceroy Installation Instructions
8 |
P a g e
USING YOUR CEILING FAN
Pairing Transmitter and Receiver – when 2 or more DC ceiling fans are installed in one location
When two or more fans are located near each other, you may want to have the receiver/transmitter for each fan set to a
different code, so that the operation of one fan does not affect the operation of the other fan/s.
NOTE:
Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE:
Ensure power to the receiver is ON prior to pairing the transmitter with the receiver.
Transmitter / Receiver pairing for Ceiling fan 1:
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
Slide the cover of the battery compartment of the transmitter to access the DIP switches. This will be transmitter 1.
Fig.9
Change the position of the DIP switches in the remote transmitter 1, so that it will be different to transmitter 2.
Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own isolation
switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
Press and hold the “
SET
” button of
transmitter 1
for 3-5 seconds within 60 seconds of switching the power ON to
the receiver of ceiling fan 1.
The fan will move slightly and stop to indicate the paring process is activated.
If the fan has light kit attached, the light will flash on and off to indicate the paring process activated.
Turn ON and change the speed of the ceiling fan 1 by the transmitter to check the operation and successful paring.
Transmitter / Receiver paring for Ceiling fan 2:
Turn off the mains supply to the receivers of both ceiling fans 1 and 2.
Slide the cover of the battery compartment of the transmitter to access the DIP switches. This will be transmitter 2.
Fig.9
Change the position of the DIP switches in the remote transmitter 2, so that it will be different to transmitter 1.
Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Turn on the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own isolation
switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
Press and hold the “
SET
” button of
transmitter 2
for 3-5 seconds within 60 seconds of switching the power ON to
the receiver of ceiling fan 2.
The fan will move slightly and stop to indicate the paring process is activated.
If the fan has light kit attached, the light will flash on and off to indicate the paring process activated.
Turn ON and change the speed of ceiling fan 2 by the transmitter to check the operation and successful pairing.