9
FULL BODY VIBRATION | SUPER VIBE 2000 USER MANUAL
Following are instructions for adding and changing the User-Defi ned Programs.
Programming instructions for U1, U2, and U3 are identical. Before starting the machine,
press the MODE
button until U1 appears on the display. Next press the USER-DEFINED
PROGRAM
button on the base of the machine and U1 will begin fl ashing. A bar will
appear above both the
and
. You may now begin programming the fi rst cycle of
U1. Press the left
button to set the oscillation speed. The speed selected will be shown
on the left of the screen display. Press the right
button to set the spiral speed. The
speed will be shown on the right of the screen. Speeds selected may range from 0 to 60
(selecting 0 means the corresponding motor will not run during that cycle of the program).
Press the TIME UP or TIME DOWN button to set the running time for the cycle. The time
selected will appear on the display, e.g., 20 seconds will appear as Time 20. Press the USER-
DEFINED PROGRAM button on the base of the machine. This records the programming
information you have selected in cycle 1 and advances to cycle 2 within the U1 program.
You may continue to program up to 12 cycles using the procedure described above, or you
may skip subsequent cycles by pressing the USER-DEFINED PROGRAM
button on the
base of the machine until U1 stops fl ashing.
To change an ENTIRE program, locate the User-Defi ned Program that you desire by
pressing the MODE
p
p
p
p
button until it appears, and then repeat the instructions in the
previous paragraph. Remember, if you have programmed 12 cycles within a program, you
must change each one individually. To CHANGE ONLY SELECTED CYCLES within a program,
press the USER-DEFINED PROGRAM
button on the base of the machine until your
program cycle appears and then make your changes as described above. Press the USER-
DEFINED PROGRAM
button again to record your changes.
Note:
a. The programming of U2 and U3 is the same process as the programming of U1.
b. The program will repeat automatically until the total system time is fi nished, and
then it will stop.
c. You can press the START/STOP button
to stop the machine at any time. The
system will return to the Manual Mode. You can press the MODE button
to
choose the program at this time and press the START/STOP button
to run it.
d. During operation, you can press the START/STOP button
at any time to stop it.
e. During the running of U1, U2, and U3, only the START/STOP button
is active.
Operating Instructions (continued)
