2.5. Cleaning
Before commencing any maintenance or cleaning activities, switch the device o
ff, and then remove the plug
from power outlet!!! All repairs and maintenance should be performed by authorized personnel only. You
should absolutely protect yourself against accidental switching the device on by unaware persons.
Usage
How often the appliance needs to be cleaned depends on how frequently it is used and what types of
products are usually stored in there.
Detergents
Dry the appliance on the inside and outside. Use a neutral detergent. If you use another detergent, finish
the cleaning with a neutral one.
The following detergents are not to be used:
- detergents that contain chloride
- detergents that contain hypochlorite
- detergents for polishing silver
- see also the next point
Products with PMMA details
During cleaning the details made of PMMA material, only a mild soap solution may be used. Warranty does
not cover the usage of other detergents.
Amount of water
Avoid using too much water because the electrical components could be damaged. It is strictly forbidden to
shower the water directly on the outside or inside of the appliance.
Condensers
Condensers should be cleaned at least once every three months or even more often, if the appliance is
used under dusty conditions. Before cleaning, the power supply should be switched o
ff and the plug should
be pulled out of the wall socket. During cleaning a hoover or a soft brush may be used. If the condenser is
brushed, make sure that the aluminum disks will not be damaged.
Drip slides
Check that the drip slide drain pipe is not clogged with dirt or dust. How often this must be done depends on
how frequently the appliance is used.
Cooling compartment
In case of daily usage the inside of cooling compartment shall be cleaned at least once a week, otherwise
there is a risk that acids or salts may damage the inside of the appliance.
2.6. Service
While servicing the appliance and the showcases, the cable cord shall be pulled out. The transformer's power
supply is connected in such a way that it does not break after turning o
ff the appliance using the switch.
2.7. Technical info
