ASSEMBLY INSTRUCTIONS
1.
Make a hole in the ground of Ø13.5cm and 18.5cm deep to set the
casing (B) into, and provide a gravel drainage system 20-30cm deep
if the ground is sandy. If the lamp is to be set into concrete, provide
for the most suitable drainage system.
IMPORTANT: Carry out a trial by filling the hole with water and
waiting 30 minutes; if the water has not drained away completely by
this time, fit an extra drainage system.
2.
Remove the three screws (A) y extract the part (B).
3.
Insert the casing (B) in the resulting hole, running the power cable
(C) through inside it and fill the hole to make it even with the
surrounding surface. Enough length of cable must stick out above the
ground to make the power connection.
NOTE: Before filling in with cement, make sure the threaded holes in
the top are in the right position for the light fitting to face in the
desired direction once installed.
IMPORTANT NOTICE:
Caution : to avoid possible electrical shock, make certain
electricity is shut off at main panel before wiring
B
A
C
B
3
2
Ø13,5 cm.
18,5 cm.
20 - 30 cm.
Mains power cable
Gravel for drainage
1
Extra drain pipe