Ground Cable
●
At least 8 gauge should be used for the ground connection to the amplifier.
●
The amplifier ground should be connected directly to the chassis of the vehicle, to bare metal.
●
The cable length should be kept to an absolute minimum.
●
It is not recommended that you connect the ground cable to the vehicles seatbelts anchor point.
Remote Turn On
●
A minimum of 18 gauge cable should be used for this connection.
●
The cable should be run with exactly the same care and attention as the power cable and taken back to the source
(headunit) and joined to the remote cable provided.
●
If the source (headunit) does not have a remote turn on cable then a 12v supply should be used. This will require a
switch to be fitted inline to enable the amplifier to be turned on and off. Remember that if this switch is left on you will
flatten the car battery.
RCA Cables
●
Depending on the model number of your amplifier and the number of speakers you wish to power you will have to run
either one or two RCA cables from the source to the amplifier.
●
Please take extra care when running these cables from the source to the amplifier. Ensure that they are placed away
from all items that can generate any interference, wiring harnesses etc.
●
It is recommended that the RCA cables should be run on opposite sides of the car to the previously installed power
cables if possible, to avoid the cable picking up interference.
Auto Sense
●
The LiteBox amplifiers feature a Patent pending auto sense circuit.
●
This circuit allows the Litebox amplifier to switch on without a remote turn on wire when connected to the speaker
outputs of a factory headunit .
●
The LiteBox auto sense circuit senses the power IC used in most headunits as opposed to sensing signal, providing
much more consistent operation and also eliminating annoying turn on thumps and flat batteries associated with
inferior signal sensing circuitry.
●
When the auto sense circuit is used the remote terminal of the amplifier becomes a sw12 volt output that can
be used to turn on other components in the audio system such as equalizers, crossovers and other amplifiers without
the auto sense function
Auto Sense Procedure
●
Connect the supplied RCA to speaker level to the speaker output of the headunit
●
Set the INPUT LEVEL switch to HI
●
Set the AUTO SENSE switch to ON
130.com.ua
Autogood products Internet store “130”