Viavi mA-3A01, Operation Manual

Page: 37 / 46

Chapter 4 Care and Maintenance
Module Removal/Installation Procedures
mA-3A01 AXIe Mass Storage Module Operation Guide Rev. B0
Page 4-4 April 2020
Module Removal/Installation Procedures
This section covers removing and installing the module. The procedures in this section are
intended for Qualified Service Personnel.
Removing the Module
How to Remove Module
1 Power down the Chassis.
2 Fully loosen the captive screws on each side of the module.
3 Grasp the module Securing Latches and pull the Latches outwards and away from
the module to disconnect the module from the Backplane Connectors.
4
Pull until the Securing Latches are at a 90° angle with the front of the module. See
Figure 4-8 on page 4-6 .
5 Grasp the module and pull to remove the module from the Chassis.
If the module is being returned to the factory for service, refer to section “Shipping the
mA-3A01” on page 4-7 for important information.
CAUTION
Modules are ESD sensitive and should only be installed, removed and/or serviced by
Qualified Service Personnel.
Mise en Garde
Les modules sont sensibles aux DES et ils doivent seulement être installés, enlevés ou
entretenus par du personnel de service qualifié.