Chapter 2
Getting Started: Setup and Operation
Operating and Navigating the User Interface
Rev. 001
CX300 ComXpert Operation Manual
22130634
2 - 18
February, 2022
To Define Values using Numeric Keypad
1.
Use the number keys on the keypad to enter the desired value.
2.
To enter the value using the current unit-of-measurement, press the
Apply
button
.
3.
To enter the value using a new unit-of-measurement, select the desired
unit-of-measurement button. The new value is applied.
2.8.2.3.2 Numeric Slider
The
Numeric Slider
bar allows the user to select and change a defined range of
values. The values to be changed are indicated by a bounding box (the light blue
highlighted area).
shows the bounding box around the number ‘500.’ The
position of the bounding box adjusts the precision setting.
The
Left
and
Right Arrow
button
s are used to adjust the size of the bounding box,
defining the last value selected in the bounding box.
Once the digit range is selected, the value is increased or decreased by dragging the
Slider Bar
or pressing the
Increment Up
and
Decrement Down
arrows. Values are
active at the time that they are being changed.
Step Backspace
The
Step Backspace
button
undoes the last
action.
Undo Button
The
Undo
button
terminates an edit that has not
yet been applied.
Apply Button
The
Apply
button
confirms and enters the defined
settings and closes the Numeric Keypad.
Enable the
Pin button
) to keep the Numeric
Keypad open after the
Apply button
is pressed.
Units Buttons
Pressing a unit-of-measure button applies the
parameter in the selected unit.
The units of measure that are available on the
keypad depends on the parameter.
The user can also commit with the external
keyboard. Example: pressing 'k' will commit the
entered value as kHz, 'm' for MHz, etc.
Table 2-5 Numeric Keypad Controls and Settings (Continued)
Control
Name
Description