3.
Tap the <
Pulse Oximeter
> icon.
4.
The display will then show your PLETH waveform, SpO
2
and pulse rate.
The device will monitor continuously, however no data will be saved until you
press the button.
5.
Press the button to start collecting your SpO
2
data. The countdown bar moves
from left to right.
6.
When the bar is fully filled, the device will analysis your data, and then show the
measurement result.
2.6
Sleep Monitor
Checkme offers a non-invasive method to monitor sleep status for adult users who
have sleep problem, sleep related breathing disorders and obstructive sleep apnea.
Warnings and Cautionary Advices
Before using as a sleep monitor, please ensure the battery is fully charged.
To start a sleep monitor measurement,
1.
Tie the wristband on one of your left hand.
2.
Insert the SpO
2
cable into the multi-functional
connector.
3.
Put one of your finger into the sensor. Forefinger or
middle finger is suggested. If needed, remove the
colored nail polish from the finger. Make sure that
the sensor is correctly placed so that the cable goes
above your hand back.
4.
Press the Home button to enter the Main Screen. Then Tap the Sleep Monitor
icon to enter the screen as below.
5.
Tap the button to start the sleep monitoring. During monitoring, a countdown
timer is always displayed at the lower left part.
6.
You can press Home button to lock the screen, as shown below. The device will
work in a very low power consumption mode.
7.
Insert the device into the wrist band cover, and then begin to sleep.
13
