K7MKLE
System Board 15
It should take no force to install the processor, this is a zero insertion force (ZIF) socket. If
it takes any force you are doing something wrong. Check the pin alignment and also make
sure the release lever is raised up completely.
After placing the CPU lower the release lever to lock the processor in place.
Now with the processor properly installed, you can proceed to install the heatsink.
It is important to note that If you have never installed a heatsink on an AMD
Athlon or AMD Duron processor before it may be difficult. We recommend you
do a dry run a few times before doing the final installation. To allow you to do this
read the following instructions. Do not remove the film on the thermally
conductive compound until you are ready to do the final installation.
STOP
WARNING:
Never run the processor without the heatsink properly
and firmly attached.
Step3
The picture below shows the bottom of the heatsink. Notice the step in the
heatsink surface, this portion fits over the top of the socket, where the legend
"Socket 462" is molded into the plastic. The heatsink must be mounted with this
step above the top of the socket or the heatsink will not be touching the processor
properly.
The next picture shows the removal of the plastic film from the thermally conductive
compound. The thermal compound is a thin layer of material that increases the efficiency of
the heatsink by filling microscopic surface voids in the processor or heatsink surface with a
thermally conductive material. Please do not remove the plastic film until you have
practiced installing the heatsink and mounting the clips on the socket. It can take a few tries
to get used to doing this.
