Hardware Setup
2-11
Case Connectors: F_PANEL
The connector block F_PANEL allow you to connect to the Power Switch,
Reset Switch, Power LED, HDD LED and SLED on the case.
PIN SIGNAL PIN
SIGNAL
1
3
5
7
9
11
13
15
PW_LED-
NC
NC
SPEAKER-
NC
2
4
6
8
10
12
14
16
HD_LED-
PW_BN+
PW_BN-
RST_SW-
SLP_LED-
Power Button (PW_BN)
Connect to a 2-pin switch button. Pressing this button will turn the system
power on or off.
Reset Switch (RST_SW)
The Reset Switch is used to reboot the system rather than turning the power
ON/OFF. Avoid rebooting while the HDD is working. You can connect the
Reset Switch from the system case to this pin.
Power LED (PW_LED)
The LED is lit when the system is power on. If the system is in S1 (POS -
Power On Suspend) or S3 (STR- Suspend To RAM) state, the LED will blink.
HDD LED (HD_LED)
HDD LED shows the activity of a hard disk drive. Avoid turning the power
off while HDD LED is lit. Connect the HDD LED from the system case to
this pin.
Sleep LED (SLP_LED)
The SLED is lit when the system is in the S1 (POS - Power On Suspend)
state.
Speaker (SPEAKER)
The speaker from the system case is connected to this pin.
1
F_PANEL
2
15
16
