VHT Amplification THE STANDARD 18, User Manual

Page: 7 / 12

B. THE REAR PANEL
Fig. 2: The Rear Panel
14. Internal Speaker Jack 8 ї : Plug-in connection for the 8 ї internal speaker. A speaker must always be connected at this jack when the amplifier
is ON. A speaker impedance load of 8 ї should be used to avoid distortion or damage to the amplifier. **
15. External Speaker Jack 16 ї : Plug-in connection for an external speaker. This jack is wired in parallel with the Internal Speaker Jack and affects
the speaker impedance load. Use 16 ї minimum total. **
** (
Please note: you can only use the 8 ї or 16 ї speaker jack - they cannot be used simultaneously
) **
16. Fuse Holder: The fuse is the amplifier ’ s protection device. In the event of an over power malfunction, the fuse will blow, disconnecting
the power source and the amplifier, therefore preventing the amplifier from severe damage. If the amplifier shuts down while in use, unplug
the amplifier, open the fuse holder, check the fuse and replace if necessary (Replaced fuse must be at the same rating voltages and current.
Consult a qualified service technician if problem continues).
17. Power Cord: Connect to a grounded A/C outlet in accordance with the voltage and frequency ratings specified for your amplifier.
17
15
14
16
7