Important safety information
Please observe the following safety precautions when using your Koryuu Transcoder.
Use the correct power supply
– The Koryuu Transcoder is designed to run with a 5 volt barrel jack
power supply unit (PSU) supplying at least 1 amp of current. The tip must be 2.1 x 5.5mm and
centre positive. Please ensure your power supply meets these requirements. Never connect a power
supply that supplies more than 5 volts. Doing so can damage the Koryuu Transcoder.
Turn off the power before connecting/disconnecting equipment
– To prevent damage of the
Koryuu’s integrated circuits, always turn off the power before connecting to a display or a device.
Be careful when connecting and disconnecting cables
– Do not apply excessive force. Some
component video cables attach too tightly and can damage your Koryuu. Use a cable that fits firmly
without needing excessive force to insert or remove it.
Do not expose to moisture
– Droplets of moisture may contact the PCB and cause a short circuit.
Never submerge the unit in water.
Keep away from fire or high heat sources
– Koryuu Transcoder is not flammable but high
temperatures, such as those from a fire or electric heater may melt the plastic casing.
Please supervise children
– Koryuu Transcoder is not a toy and is not designed for use by children.
Please supervise children if they use the Koryuu Transcoder.
