![background image](http://html1.mh-extra.com/html/vetus/v-docker/v-docker_operation-manual-and-installation-instructions_1010489027.webp)
020702.01
27
vetus®
Installation Manual V-docker
Preliminary
THRUSTER
ACTUATOR
THRUSTER
HUB
HUB
HUB
TERMINATOR
CAN
POWER
SUPPLY
HUB
CONTROL
PANEL
I/O BOX
CONTROL
PANEL
I/O BOX
System with two (2) control panels
11 Setting procedure
After all parts have been electrically connected to each other the set-
ting procedure must be carried out.
W
arning
The setting procedure must be done
before
the push-pull cables
are connected to the engine,
And while the boat is moored.
• If already installed, unscrew the 4 screws securing the cover.
• Turn the cover of the actuator unit upside down.
• Remove the rubber plug.
1
2
3
• Look through the hole to see 2 push button switches and a row
of DIP switches.
• Adjustment of the actuator can be carried out by using these
switches.
W
arning
Be careful, when using a screwdriver to operate the switches, to
prevent short circuit or damage to the electronic circuitry.
• Switch on the power to both the CAN bus and the actuator.
• Set DIP switch S4 in position ON.
S4 in position
ON
SETUP
S4 in position
OFF
RUN (Normal operation)
4
SETUP
ENGLISH