0370401.01
13
vetus®
Owner’s manual E-Line motor control lever ELPS
1
2
3
4
3 .7 Configuring a panel for the steering position
where the panel is placed
1 x
Carry out the following actions on EACH panel in the order indi-
cated:
N.B. The panel must be in the OFF position (if the panel is NOT in the
OFF position, first long press the "ON/OFF" button to turn the panel
to the OFF position.
2 Place the panel in configuration mode.
• Press and hold the 'ON/OFF' button for 10 seconds.
OR
Helm station
Helm station
1 BLUE, flashing
2 RED, flashing
3 BLUE, flashing
RED, quick flashing
4 BLUE and RED,
simultaneously flashing
1
2
3
4
1
2
3
4
didahdi ( . − . )
3 Press the 'ON/OFF' button to
confirm. Now the panel is in
configuration mode.
During the first 6 seconds, the buzzer will continuously signal a did-
ididididi ..... (. . . .). Keep pressing the On / Off button. After 10 seconds
the buzzer sounds the signal dididididah (. . . - -).
4 Select the steering position where the panel is located by moving the lever momentarily from neutral to
the left or right and back again. The color and the flashing of the LED indicate the number of the helm
position.
5 Press the 'ON/OFF' button
once to confirm the setting.
10 seconds
seconds
Configuration mode
seconds
6
dididididididid ( . . . . . . )
dididididah ( . . . . − )
4
5
n
ote
For a port and starboard panel, together on a helm station, the
set helm station number must be the same .
n
ote
Settings are retained when the power supply is switched off!
1
2
3
1 Move the lever to the right.
ENGLISH
