BATTERY INSTALLATION
The C-25 uses a common
3032 3v
lithium button cell battery. Replacement
batteries are available at most camera shops and from your Vetta retailer. Under
normal usage a battery should last approximately one year.
NOTE:
Most
problems that occur with cycle computers are caused by dead or weak batteries.
If you are having problems with your computer's operation, check and replace the
battery first.
STEP 1
Remove the battery cover from the bottom of the computer using a coin.
STEP 2
Install the battery into the battery compartment with the positive (+) side of the
battery facing the compartment door. Be careful when you are installing the
battery not to bend any of the battery contacts.
STEP 3
Screw the battery cap firmly into place making sure that the rubber o-ring seal does
not get pinched or distorted as this will compromise the waterproofing of the unit.
3032 3v Lithium Battery
AUTO CLEAR BUTTON
Press for total reset of unit.
All stored data will be erased.
!
CAUTION
“A” BUTTON (LEFT BOTTOM)
Advances through the primary functions (Speed, Trip Distance, Ride and Total
Time Stopwatches).
Changes from Bike 1 to Bike 2 (Hold for 2 seconds).
“B” BUTTON (LEFT TOP)
Advances through the secondary functions (Temperature, Average and Maximum
Speeds, Clock and Total Odometer).
Begins programming sequences (Hold for 2 seconds).
Sets and advances the screen while programming.
“C” BUTTON (RIGHT)
Starts and stops the manual stopwatch.
Resets the stopwatches and odometers (Hold for 2 seconds).
Adjusts the digits while programming.
BUTTON FUNCTIONS
“A”
“C”
“B”