MAGNET, SENSOR AND BRACKET INSTALLATION
We recommend that you install your C-16 in the following manner, starting with
the sensor unit on the fork and working up to the mounting bracket on the handlebar.
STEP 1
Mount the new Vetta universal S-2 sensor (pat. pend.) loosely (so that you can
slide it around) to the fork blade using the zip-tie provided. The sensor can be
mounted at any point along the fork, however, we recommend a position on the
back side and near the top of the left fork blade. This will protect the sensor from
being hit by rocks, trees and other objects.
STEP 2
Again, loosely install the sensor magnet to one of the spokes on the left side of
the front wheel. Adjust the magnet and sensor position by sliding both pieces
around until you get the sensor as high on the fork blade as possible while still
maintaining the necessary magnet to sensor spacing (1-2mm).
NOTE:
The magnet
should pass within 1-2mm of the sensor, and the top of the magnet should be no
higher than the top of the small arrow molded into the face of the sensor.
Sensor
Zip-Tie
Alignment
Arrow
Fork Leg
Wheel
Magnet
1-2mm
Wiring Diagram
!
!
STEP 3
Route the sensor wire up the back of the fork securing with electrical tape.
CAUTION
Do not use zip-ties to secure the sensor wire to the bike as this
may result in cut or broken wires.
CAUTION
Be sure to leave enough slack in the wire to allow for the steering
motion of the bike and the action of the suspension fork, if you have one.
STEP 4
Carefully wrap the excess sensor wire around the front brake cable housing,
securing with electrical tape when necessary. When you are finished, you
should have just enough slack for the computer mounting shoe to reach the
handlebar.
Check to make sure that all of the excess sensor wire is either taped down or
wrapped around the brake cable so that nothing can catch on it while you are riding.
