page 2
Table of contents
Page
Introduction, Keyboard Functions
2
Configuration and Setup Menu. Display
3
Parameters
4
Calibration
5
Specifications and Displayed Error Codes
6
Fault localization and repair
7
Instruction for handling
8
Introduction
Veteks new VB2 series of Weighingblocks are rugged digital Force Meter made in strong aluminum. It comes standard with a large
(.75") LCD screen for easy readout. All setup parameters may be entered via the membrane panel keys. The Force Meter has an
”intelligent” auto power off function.
The Force Meter is developed for general force measuring The setup parameters are altered through the Setup menu while a
few other parameters are altered through the User menu. The configuration section of the manual explains how to use
the five front panel keys to maneuver and save settings in both menus.
The Force Meter is equipped with 9 V alkaline battery. If the battery is not good enough to ensure a correct value the
Force Meter will turn off.
Keyboard functions
The calibration switch besides the battery is only for calibration.
Indicator ON
Normally disabled.
Toggles between Gross and Net
weight/force display only if a Tare has been established.
Sets Force Meter to display "0"
when in Gross mode, and within zero band range.
When pushed in
for 3 seconds, the Force Meter switches off.
Used to establish a Tare (
zero the Force Meter
) while in either Gross mode or
Net mode. This operation cannot be performed at or below Gross zero.
ON
NET
GROSS
OFF
ZERO
TARE
O
Hantverksvägen 15, 76493 Väddö Sweden
Tel +46 176 208 920
info@vetek.
com
www.vetek.
com
