user manual
www.vetek.com
10
CommUNICATIoN PoRT (NoT VAlId foR UNISCAle)
TheSe INSTRUCTIoNS ARe oNlY VAlId foR The NeW deSIGN, WITh WAIST ANd RoUNded CoRNeRS
(foR UNITS ShIPPed AfTeR 2003-03-01).
PRINTeR foR The WeIGhT VAlUe
many printers in the market can be connected ( e.g. martels mCP9800).
for more information, contact Vetek AB.
PC/NoTeBook
The Scale can be connected to a PC/Notebook. for more information, contact Vetek AB.
SoleNoId modUle VBB-10
(NoTe: ThIS fUNCTIoN IN VB2 IS STANdARd foR SCAleS delIVeRed AfTeR mARCh 2003)
one time set up: f11 must be “1” and A5 must be “2” (normally done when delivered).
hANdlING
1. mount the Solenoid module to the cylinder.
2. Connect the ”zero modem cable” and the mains cable. (for the points 3 – 10 below it is no need for the
Scale to be on the floor, you can keep it in your hands)
Start the Scale with oN and wait a few seconds.
3.
To set the Batching Weight:
4.
Press, ”Dot”, display shows 0,0 (flashing).
5.
Press ON until the first relevant digit flash.
6.
Change to the wished value with ”dot”.
7.
Press ON until the next relevant digit flash.
8.
Change to the wished value with ”dot”.
9.
When the Scale shows wished value, save with NeT
10.
Press ZeRo it the Scale not shows zero and put the object on the Scale. The Scale shows the gross weight.
11.
Batching: Press TARe. The Scale shows zero and the valve is opened.
12.
When the weight difference on the Scale is same as Batching Weight the valve will close.
13.
The Scale shows the Batching Weight. Press NeT/GRoSS for gross weight.
14.
GeNeRAl AdVICe
•
Batching too quickly gives less accuracy.
do not touch the tube to the cylinder during batching.
•
VBB-10 CoNSIST of:
VBB-10-10 Box WITh SoleNoId
VBB-10-11 “ZeRo modem CABle” 9-PIN femAle/femAle
VBB-10-12 mAINS CABle.
