S
LNM
, Manual
Copyright 201
5
Vestil Manufacturing Corp.
Page 3 of
1
4
S
AFETY
G
UIDELINES
Failure to read and understand the instructions included in this manual before using or servicing
the
stacker
constitutes misuse of the product
.
Study the entire manual before you use the
stacker
for
the first time and before each subsequent use
.
Read the manual to refresh your understanding of the safe
use and maintenance procedures. If questions remain after you finish reading the manual, contact Vestil for
answers. DO NOT attempt to resolve any problem with the
unit
unless you are
certain
that it will be safe to use
afterwards.
To decrease the risk of electrocution:
DO NOT
contact
or
operate
the
stacker
close to
electrified wires or other sources of electricity;
Before operating the SLNM , always inspect the area where you will use it.
Improper use might result in serious personal injuries to the operator and/or bystanders. To
minimize the possibility of injury, ALL
persons who might operate, perform maintenance on, or service the SLNM
must read, understand and apply the following instructions:
DO NOT operate the SLNM unless and until you are:
1. Trained to use
the machine; AND
2. Certified as a trained operator by your employer in accordance with U.S. OSHA regulations (29 CFR
§1910.178) and any standards incorporated by reference (e.g. ANSI/ITSDF B56.1-2005).
DO NOT attempt to lift or transport loads that exceed the rated capacity.
Inspect the machine before each use; DO NOT use the
SLNM
unless it is in normal condition. Normal
operating
condition exists if the
SLNM
passes the inspection and functions tests described under the heading,
“Inspect
& Perform a Functions Tests”.
DO NOT use the unit until you read and understand the entire owner’s manual. Review the manual before
each use AND before performing maintenance on the device.
DO NOT use the
SLNM
if the load-supporting elements sustain any structural damage. Structural elements
include, but are not limited to, the forks, carriage, and wheels. If structural damage is present, immediately
tag the unit “Out of Service” and inform maintenance personnel of the problem.
DO NOT use the
SLNM
if it makes unusual noises during operation.
DO NOT allow people to ride on the
stacker
.
DO NOT attempt to lift an unevenly distributed load. Always center and evenly distribute the load on the forks.
DO NOT operate the
SLNM
on surfaces (ramps or grades)
.
DO NOT leave the
SLNM
unattended while it supports a load. Always fully lower the forks, and then
completely
disengage the skid or pallet.
Unauthorized
DO NOT modify the
stacker
without first receiving written authorization from Vestil.
modifications may make the
SLNM
unsafe to use.
To maximize the service life of the
SLNM
and to prevent damage:
Always store the machine in a secure, dry location where it will not interfere with traffic or other activities.
Maintain the product as suggested in “Maintenance & Inspections”.
R
EMOVING THE
Narrow mast
Stacker
FROM THE
S
HIPPING
P
ALLET
:
Narrow Mast
stacker
is shipped in ready-to-use condition. However, it must first be removed from the shipping
pallet
before it can be used for the first time.
DO NOT attempt to
pull
the
Stacker
off of the pallet; it might tip over and cause bodily injuries or
property damage. To minimize the risk of injury to yourself or other persons, perform the following steps to
remove the machine from the shipping pallet:
1. Remove all packing material.
2. Inform all personnel not participating in the unpacking process to clear the area.
3. Lift the
SLNM
off of the pallet using a hoist or a with a capacity of at least
,000 pounds. Always
apply the proper hoisting procedures or forklift operation practices you learned during your training program.
