3
seated the in the top of the guide rail. The upper side support and the
crank of the mechanism must face in opposite directions. Do not yet
tighten the clamping screw of the guide rail.
Now slide the frame’s guide rail over the upper sliding insert of the
platform, inserting the spindle though the hole in this until the frame is
standing on its wheels on the floor. The gear housing will be pushed
out of the guide when the spindle contacts the lower sliding insert of
the platform. Turn the crank clockwise to move the threaded spindle
down though the lower insert, until the locater of the gear housing is
again seated in the guide and the bottom of the housing is resting on
the guide. Now, the clamping bolt may be tightened.
The second unit is assembled in the same way.
4. Precautions and preparation
4.1 The floor must be absolutely level, smooth and clean. There must
be no inclines or slops to be moved over. Make sure that the floor
and the floor covering are to stand up to the loading imposed by
the wheel and whether the can take the weight of the furniture
being transported.
4.2 Check whether the piece of furniture to be transported contains
any loose objects. These will have to be removed, or secured
against sloping out of position.
4.3 Check whether the piece of furniture is strong enough for the two
opposite side to take the weight of the piece via the transport
units can hold the furniture to be transported without damaging it.
4.4 Find the weight of the piece of furniture to be transported. The
maximum load of 600 kg/pair =300 kg for each unit must not be
exceeded.
4.5 Find the center of gravity of the furniture to be transported. Along
the furniture base, it is the decisive for the load that a single
transport unit can beat, across the base, for the center of the
transport unit, and, in connection with the height, for the moment
of tilting that occurs when moving the furniture. When in use, the
height of the center of gravity must not exceed 0.8m. the distance
of the transport units to one another must not be less than 0.5m
and not gravity 4.0m (furniture of the securing straps).
4.6 Never use this equipment for towing behind a vehicle.
5. operation
Before use, the transport components should be checked for function,
Summary of Contents for MFM-1300
Page 1: ......
Page 3: ......
Page 7: ...6 38 Woven belt 1 39 Lifting platform 1 40 Cargo lashings 1 41 Nut 1 42 Screw 1...
