Assembly Instructions
Vestil ships winch lifts to its customers in a mostly assembled form. The minimal assembly that is required differs by
model, so follow the directions that correspond to your lifter.
If you purchased an
A-Lift-R or A-Lift-S,
you will receive 3 pieces:
- 7 -
Support leg
openings
1). Main Assembly
3). Box 2 contains:
forks (2).
2). Box 1 contains:
standard support legs (2),
fork retaining pins (4), winch handle (1).
Step 1: Connect the support legs to the main assembly by following instructions (a) through (e).
(a) Insert a support leg into each of the
openings in the main assembly.
(b) One at a time, pull the retaining pegs
to allow the legs to slide further into
the openings.
(c) Slowly release the pegs. You may
have to wiggle the leg to get the peg
to drop.
(d) Pull upwards on each of the support
legs to verify that they are held in
place by the pegs. The legs should
not be able to slide out of the opening
(e) If a leg comes out of the opening, the
corresponding peg did not engage
properly. Repeat (a) though (d).
Spring-loaded retaining peg
Step 2: Lift the assembly to the upright position (photo a), lock the brakes (photo b) and fasten the winch handle to the
winch body (photos c – f).
Engage the brakes by
pressing down on the
brake actuator
Remove the handle
retaining bolt and washer
(circled)
c
b
a
Handle connector
Winch body with bolt and
washer removed
d
