Vestfrost SZ...R, Instructions For Use Manual

Page: 2 / 16

2
GB
Thank you for purchasing your new re-
frigerator from Vestfrost. Please note that
these instructions apply to all refrigerators
in the SZ range. Illustrations and fittings
may therefore not necessarily correspond
exactly to your model.
Warning
As the refrigerant used in this appliance is a
flammable gas (Isobutane R600a), special
care must be taken to prevent damage
to the refrigerant circuit and piping during
transport and installation.
If damage does occur, avoid sparks or
naked flame in the vicinity of the appliance,
ensure that the room is well ventilated,
disconnect the power supply, and contact
your supplier.
The unit must only be serviced by quali-
fied technicians from an approved service
centre.
Old appliances
Old refrigerators and freezers are often
fitted with complicated latches that can
only be opened from the outside. If you
have one of these old units stored away
somewhere, or if you scrap one, remember
to destroy the latch first in order to prevent
children from being exposed to great dan-
ger by getting locked inside the unit.
Disposal
This appliance contains recyclable materi-
als. Before disposing of the unit, detach the
plug from the cable and remove the door.
If the door is left on, the appliance is highly
dangerous for children at play.
Environmental regulations on disposal must
also be observed. When disposing of the
appliance you should contact your local au-
thority technical department who will inform
you of how collection and recycling of such
units take place in your area.
Before use
Before operating your new appliance,
please read the following instructions care-
fully as they contain important information
on safety, installation, operation and main-
tenance. Keep the instructions for future
reference.
On receipt, check to ensure that the appli-
ance has not been damaged during trans-
port. Transport damage should be reported
to the local distributor before the refrigerator
is put to use.
Remove the packaging. Clean the inside of
the cabinet using warm water with a mild
detergent. Rinse with clean water and dry
thoroughly (see cleaning instructions). Use
a soft cloth.
If during transport the appliance has been
laid down, or if it has been stored in cold
surroundings (colder than +5°C), it must be
allowed to stabilise in an upright position for
at least an hour before being switched on.
Contents
Get to know your refrigerator............3
Installation and start-up....................4
Reversing the door...........................7
Electrical connection.........................8
Operation and function.....................9
Layout and fittings..........................10
Defrosting,
cleaning and maintenance..............11
Fault finding....................................12
Warranty,
spare parts and service..................13