VESTEL VEA34706, Operating And Installation Instructions

Page: 36 / 79

EN - 17
The hob control will then go into S-Mode.
A buzzer signal will appear at the
same time After 10 minutes the buzzer
signalling will stop.
If there is no erroneous operation present
any longer, both the visual and the buzzer
signal will disappear.
Over Temperature Switch Off
Since the placement of the control is very
close to the heater in the middle front of
the hob, an incorrectly placed pot half
on the control, which is not sensed by
the sensor safety cut off (not covering a
button), heats up the hob to a very high
temperature, which makes the glass
and the buttons extremely hot, which
will result in burning.
To prevent the hob control unit from
damage, the control monitors all the time
the temperature and switches off in case
of overheating emergency.
It is indicated in heater 4 heater display
with the letter ´t`, for all the time until the
temperature decreases.
After the temperature falls, the ´t` displays
will be erased and the hob control unit
will fall back into the S-Mode. This means
that the user can reactivate the appliance
by touching .
Operating Time Limitations
The hob control unit has a limitation of
the operating time. If the heat setting for
this heater has not been changed for a
certain time, then the heater will turn
off automatically (´0` is displayed for 10
seconds, afterwards the residual heat).
The limit of the operating time depends
of the selected heat setting.
If a timer was associated with the heater,
then a ´00` will be displayed on the timer
display for 10 seconds, Afterwards, the
timer display will turn off.
After an automatic turn off of the heater, as
described above, the heater is operable
again and the maximum operating time
for this heat setting is applied.
Residual Heat Functions
After all cooking processes are
completed, there is some heat stored
in the vitroceramic glass referred to as
residual heat. The control can calculate
roughly how hot the glass is in the worst
case. If the calculated temperature is
higher than + 60 ° C, then this will be
indicated in the corresponding heater