VESTEL VEA34706, Operating And Installation Instructions

Page: 31 / 79

EN - 12
Turn On and Turn Off the
Appliance
If the appliance is in Stand-By-Mode, it
is put in Operating-Mode by pressing the
On/Off button for at least 1 second. The
sounding of a buzzer signal indicates a
successful operation.
On all heaters a ´0` appears and the
heater Decimal Point flashes (1 sec on,
1 sec off).
If there is no operation within 10 sec,
the display of all the heaters will turn off.
If the displays are turned off, the heater
will be set into Stand-By-Mode.
If is pressed for more than 2 seconds
(in Operating-Mode), the appliance
switches off and is set into Stand-By-
Mode again. The appliance can be turned
off by pressing at any time; even if
other buttons are pressed simultaneously.
If residual heat from a heater remains,
this will be indicated in the corresponding
heat setting Heater Display.
Select Heater
If a single heater is chosen with the
corresponding Active/Inactive Heater
Button , the Decimal Point of the related
Heater Display will flash. For the selected
heater, you can set the heat level between
1-9 by touching the Heat Setting Slider
Buttons
The slider button must be pressed within 3
seconds, otherwise the heater selection is
erased and heat setting dot will disappear
(Decimal Point). If there is no further
operation within 10 seconds, the heater
will fall back into the S-Mode.
The heat setting can always be changed
by pressing
between
level 1-9.
Each sliding operation or each display
change is quitted by a buzzer signal.
Turning on dual and triple zones (available
only in some models)
Turning on triple zones
A dual or triple zone can only be switched
on if the basic zone of a heater is set to
level 1–9 and the heater is selected, the
dot is on.
If is pressed, the buzzer signal sounds
and the Dual Zone Indicator is statically
on. If is pressed once again, another
signal is heard and the triple heater is
switched on. The Triple Zone Indicator
will be illuminated and the triple zone will
be energized.
After pressing once again, the triple
zone of the heater will be switched off
again. Each operation causes a status
change of the dual/triple zones following
in this manner (Dual zone on, triple zone
on, all extended zones off, dual zone on,
triple zone on, dual zone on, etc. ...)