- 28 -
Auto test program algorithm steps:
Steps in program algorithm fallows each other automatically. When there is a problem,
program ends and gives failure code. You can learn the error from the Service Failure Code.
Steps
Process
Time
Control
0
Show the last
failure occured
before
~6 sec
The machine shows the last error, before the sevice
programme starts
1
Drain
~4 sec
Drain pump is running
2
Fill (~3,5lt)
~1min 25 sec
Water inlet valve and flowmeter is controlled.
(At 2,5lt circulation pump starts to run)
3
Turbidity
sensor
~30 sec
(For C4 models)
4
Washing pump ~1 min 10sec
Circulation pump – detergant dispenser
5
Wash pump +
Heating
~5 min
Heater Casing (pressure switch)- NTC- diverter positions
6
Regeneration
~1 min
Regeneration valve
7
Drain
~ 20sec
Drain Pump
8
End led
highlight
Note:
The values declared above are the values obtained under laboratory conditions according to the relevant
standards. These values can change depending on conditions of product’s use and environment (network tension,
water input temperature and environment temperature)
SERVICE FAILURE CODE
While your machine is in operation, gives feedback informations. The indicators are on and
off with different combinations or the failure code appaers on display, then you can identify
the possible problem by looking the fallowing failure code tables.
