VESTEL 17MB82S, Service Manual

Page: 23 / 64

23
Supports 512Mb or 1Gb or 2Gb DDR2 and DDR3 DRAM device
Supports DDR2-1066/DDR3-1333/DDR3-1600 device
Audio DSP
Supports AC-3 (Dolby Digital) decoding and E-AC3 (Dolby Digital Plus) decoding (option)
MPEG-1 layer I/II decoding
Supports WMA / HE-AAC (option)
Support Dolby DDCO, and MS10 (option)
Dolby Prologic II (option)
Audio output: 5.1ch + 2ch (down mix) + 2ch(bypass)
Pink noise and white noise generator
Equalizer
Bass management
3D surround processing with virtual surround
Audio and video lip synchronization
Supports bass/treble
Automatic volume control
Supports 5-bit (10-channel) main audio I2S output interface, each of these channels is up
to 24-bit resolution
S/PDIF interface
Supports SPDIF in bypass
SPDIF out
Analog TV IF Demodulator
Supports world-wide analog TV standard
Accept direct IF and low IF
Full digital AGC control and carrier recovery
Embedded SAW filter and IF Amplifier. Cost effective TV front-end structure and no more
cost on:
External analog SAW filters (Video/Audio)
External analog IF demodulator
External peripheral circuit on CVBS signal data path
External SAW filter and IF VGA on tuner
Peripherals
Three built-in UARTs with Tx and Rx FIFO
Ten basic serial interfaces: one is for the tuner, four are the masters for general purpose
and two of them can be
active in standby mode, one is the slave for VGA DDC, the other four extra slave serial
interfaces used for HDMI
EDID data
Five PWMs, two of them can be active in standby mode
IR receiver
Real-time clock and watchdog controller
Built-in 2-link USB2.0/1.1, both of them support external hub with 16 endpoints.
Built-in uP for standby mode
Supports SDIO interface
Supports smart card interface