Subject to modifications.
© Vestamatic GmbH
Art.-Nr.:
1253 001 GB 2218 A05 • Vestamatic GmbH • Dohrweg 27 • D-41066 Mönchengladbach
• www.vestamatic.com
3/8
G
P R O · LL-ME-BAT/I-24/0,6 Nm RB IO-AIR
6. Startup and usage
1. The motor is in transport mode and must be woken up before first use.
2. To wake up the motor, connect a charger or a suitable power bank to
the Micro USB socket.
5V DC, min. 1 A
3. After plugging in the charger, the green and blue LEDs light up briefly.
The motor is now active.
NOTE:
Before first use, the motor should be fully charged.
i
Charging the motor
To charge the motor, a standardized charger or a power bank with at least
1 ampere output current can be used.
Charging the motor is necessary if it shows one of the listed behaviors.
–
Take a micro-USB charger or a power bank and plug the cable into the
micro-USB socket on the motor head.
–
Plug the charger into the socket. A power bank may need to be activated.
–
After approx. 1 sec the blue LED on the motor head is constantly lit. The
charging process is thus initiated. After about 1 minute the motor can
be moved again. The entire charging process can take up to 6 hours.
–
Charging is completed when the blue LED on the motor head goes out
and the green LED lights up permanently. The micro-USB connector
can then be removed from the motor head.
Motor behavior with low battery
If the battery of the motor is running low, the motor will display the following
behaviors for ensuing movements.
Blue LED flashes
The blue LED on the motor head flashes twice every 30 seconds.
Reduced motor speed
The motor only runs at low speed to signal that it needs to be charged.
Motor remains at the upper limit position
When the battery reaches a critical level, the motor automatically
goes into sleep mode to prevent damage to the battery.
Within this process, the motor drives to the upper limit position one
last time. Further commands are only executed after a charger has
been connected.
NOTE:
When charging with a power bank, it will automatically switch off
after the charging process has ended, as a result the green LED
on the motor head will go out shortly after.
i
LED-Feedback on motor head
Blue LED constantly lit
The motor is charging.
Blue LED flashes
An error occurred while loading.
Green LED constantly lit
The charging process is completed.
Green LED flashes
The motor is in programming mode.
No reaction of green or blue LED
If none of the LEDs provide feedback after pressing the programming
button on the motor head, the motor is in transport mode or has shut
down due to critical battery voltage.
