14
Preparations:
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING
THE VENT OPENING.
1
.
Determine and mark the center line on the ceiling where the range hood will
be installed. Make sure there is proper clearance within the ceiling or wall
for exhaust vent.
2
.
Due to the weight and size of this unit, please make sure that the support
system or framework being used is stable and secure in the ceiling.
3
.
Put a thick, protective covering over counter top, cooktop or range to protect
from damage or dirt. Remove any hazardous objects around the area when
installing.
4. Mark the locations of the support mounting bracket holes vent cutout (if used)
and power supply cable cutout on the ceiling. Use drill and saber saw or
keyhole saw to cut openings for power supply cable and vent (see Venting
Methods and Electrical requirements, Pages 11
-1
2
).
If venting to the outside install vent system (see venting
Methods
Page 11
).
Use caulking to seal exterior wall or roof openings.
Do not restore power until wiring is completed.
If the range hood comes with a glass canopy and has not already been mounted
to the hood, loosen the four canopy screws and washers from the hood top,
carefully place the canopy on the hood top and loosely tighten the four canopy
5.
6
.
Disconnect main electrical supply, prepare and run electrical wiring through
ceiling. Leave approximately 12” of electrical cord hanging from the ceiling.
7
.
Disconnect power cord, remove the aluminum grease filters or stainless
steel baffle filters.
.
8
.
Set aside the
filters
until the range hood is properly installed.
9
.
screws along with washers. DO NOT put excessive pressure against the glass.
Summary of Contents for Rome VRH-ROME-30SS
Page 1: ...Rome User Manual VRH ROME 30 36SS ...
Page 28: ...www vesta kitchen ...
